If I choose cat1 from report1 then go to report2 the data shows correctly. But after if I choose from the dropdown in report2, the data doesn't reflect 😞 ... View more

Hi @HunterT_SAS    I tried your way, however when I choose from the dropdown the data is not reflecting and I checked the data mapping. is there any other way? ... View more

Any solution for that? ... View more

ok i managed to make the date blank for user when view report for first time: ( 'Parameter 1'p NotIn () ) AND ( 'Parameter 1'p NotMissing ) without specifying any date 🙂 ... View more

Thanks SAM it works, however when user view the report the date is selected. is there any way to make it blank from start? or text input should have date? ... View more

Yes it's old version 7.5 ... View more

i made the changes and set the format to date for all, but still i can see the error. (This error only shown while editing the report) ... View more

where do i create the advanced filter? on the text input or table? Also, when i tried to do it either on table or text input the IsSet function gives error which is unknown function. ... View more

I want the user see this when opening the page without any data because the steps which creating parameter the assign to cal item will make the user see a date selected when opening the page ... View more

I tried it but it doesn't work, these are the steps i did: created the parameter: then assigned it to the text input: then created a calculated item based on this parameter: then i added this calculated item to the table: and now when i remove the date in text input the table gives error:       my point was when the user open the page there is no date shown in text input and table is blank ... View more

if the date is outside my range yes the graphs will be blank. however i don't want the text input to have date, i want it to be blank as well ... View more