Hi,
When publishing a decision flow in Intelligent Decisioning in Viya 4, the initial run completes successfully, however when these same flow was re-executed, it would not complete and it will just run (Please find below screenshot)
However if we put in a new name for the same flow it would complete successfully.
Any thoughts on this behavior? Thanks in advance!
Hi @alko13 ,
Yes, checked the "Replace item with the same name" option. If we try to uncheck this. The publishing will just cause an error but the expectation is that publishing job itself will still end with an error instead of it just running forever. Here are the 3 cases we have tried so far:
Hi @alexal
Please find the above screenshot for the behavior.
For this one we do not understand how to perform:
"Also, find your model here /modelPublish/models and provide a response from a log endpoint."
Appreciate any suggestions
Regards
Open that endpoint in the browser and find your model. If you cannot do that, please open a ticket with SAS Technical Support.
Are you ready for the spotlight? We're accepting content ideas for SAS Innovate 2025 to be held May 6-9 in Orlando, FL. The call is open until September 25. Read more here about why you should contribute and what is in it for you!