- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
In SAS VS Clustering, I am trying to launch clustering for 30k records, 5 clusters only. But I am receiving this notification "Maximum polylines exceeded...". I went on to set the polylines to 30k, but it went back to 5000. Such number still not able to show my clustering polylines. Is this the maximum polylines allowed in SAS VS Clustering?
Thanks a in advance.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
Five thousand is indeed the hard limit for the number of polylines. Our recommendation is to reduce the other two parameters (number of bins, visible roles) to get a smaller set of polylines. Hope this helps!
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
It seems there is a limit of 5000. I was not able to find a setting in the administration guide where this property can be increased either.
Kind Regards,
Michelle
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
Five thousand is indeed the hard limit for the number of polylines. Our recommendation is to reduce the other two parameters (number of bins, visible roles) to get a smaller set of polylines. Hope this helps!
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the reply and recommendation. Is there any technical or logical reason behind setting up hard limit of 5000?
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content