Hello:
I would like to run a logistic model in the binary outcome (Y). In the multivariates, I only need the condition 1 and 2. Therefore, I use "and" to select all of them. Am I correct? Or should I use "or"? Thanks.
proc logistic data=test;
class Y (ref="1") X1 (ref="2") X2 (ref="2") X3 (ref="2") X4 (ref="2") X5 (ref="2");
model Y = X1 X2 X3 X4 X5;
where X1 in (1,2) and X2 in (1,2) and X3 in (1,2) and X3 in (1,2) and X3 in (1,2);
run;
quit;
Only you really know based on your logic. Make some test data and ensure it behaves the way you expect.
Scenarios to test:
X1, X2, X3, X4, X5 all are either 1/2
Any of X1-X5 is not a 1/2
All of X1-X5 is not a 1/2
You may need to break these out into smaller cases but you'll probably understand your logic better at that point.
Get more insight about your data with:
proc sql;
select
x1, x2, x3, x4, x5,
count(*) as n,
case
when X1 in (1,2) and X2 in (1,2) and X3 in (1,2) and X4 in (1,2) and X5 in (1,2) then "Yes"
else "No" end as included
from test
group by x1, x2, x3, x4, x5;
quit;
Are you ready for the spotlight? We're accepting content ideas for SAS Innovate 2025 to be held May 6-9 in Orlando, FL. The call is open until September 25. Read more here about why you should contribute and what is in it for you!
Learn the difference between classical and Bayesian statistical approaches and see a few PROC examples to perform Bayesian analysis in this video.
Find more tutorials on the SAS Users YouTube channel.