Hi there!
I have followed the EG Setup instructions and I am receiving error messages when I run the second program, _2epg194.sas. The log shows the following:
ERROR: The XLSX engine cannot be found.
ERROR: Error in the LIBNAME statement.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
WARNING: Libname XL is not assigned.
ERROR: The XLSX engine cannot be found.
ERROR: Error in the LIBNAME statement.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
WARNING: Libname XL is not assigned.
ERROR: The XLSX engine cannot be found.
ERROR: Error in the LIBNAME statement.
ERROR: Libname XL is not assigned.
WARNING: Libname XL is not assigned.
ERROR: The XLSX engine cannot be found.
ERROR: Error in the LIBNAME statement.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
ERROR: Libname XL is not assigned.
WARNING: Libname XL is not assigned.
NOTE: Unable to open parameter catalog: SASUSER.PARMS.PARMS.SLIST in update mode. Temporary parameter values will be saved to WORK.PARMS.PARMS.SLIST.
Number of names found is less than number of variables found.
Number of names found is less than number of variables found.
What am I doing wrong?
Thanks!
Cass