About Mutua

Mutua · ‎01-05-2016

Thanks Keshan for the reply. I will follow up with the editor for further guidance on the issue. Best regards, Peter

Mutua · ‎11-20-2015

Many thanks for that informative email. I really appreciate. I am getting the same kind on information when i run my analysis. Going by your example, it means that F(DF1, DF2) = F(8, 9) =1.03 right? What does it mean when the DF1 and DF2 are the same? and when the P-value is small enough to enable rejection of the null hypothesis? Best regards, Peter

Mutua · ‎12-04-2014

Thanks Steve for your suggestions and answer to my question. I agree with the argument since the subject were destroyed and not replaced during the analysis. True, choosing the right model was difficult, because i choose Proc Mixed. But with the additional information, and the preference for GLIMMIX, then, i will work around and find how to carry out the analysis. Could i have more questions, i will post them out again to the SAS community. I thank you so much for your continued support in my quest to learn more Statistical procedure. Thumbs up. Peter

Mutua · ‎10-20-2014

Thanks Steve for your informative answer. I will run the analysis and if i have further question i will post it to the SAS support communities again. Best regards, Peter

Mutua · ‎04-16-2014

Thanks Ivm, for the explanation. I will give it a try and see how it works out. Regards, Peter.

PGStats · ‎04-15-2014

Please post this new question to the SAS Statistical Procedures community. That is where you will likely get the best advice. - PG

Online Status	Offline
Date Last Visited	‎01-05-2016 10:56 PM

Re: Finding levels of risks associated with t-test

Re: Finding first level risk associated with t-test

Re: Finding first level risk associated with t-test

Re: Finding levels of risks associated with t-test

Re: Finding levels of risks associated with t-test

Re: Finding levels of risks associated with t-test

Finding levels of risks associated with t-test

Re: How to obtain the two DF in Proc Ttest e.g. F(df1, df2) = XXX

Re: How to obtain the two DF in Proc Ttest e.g. F(df1, df2) = XXX

Re: How to obtain the two DF in Proc Ttest e.g. F(df1, df2) = XXX

Re: How to obtain the two DF in Proc Ttest e.g. F(df1, df2) = XXX

Re: Finding levels of risks associated with t-test

Re: How to obtain the two DF in Proc Ttest e.g. F(df1, df2) = XXX

Re: Repeated measurements analysis....Which is the best SAS procedure?

Re: Analysis of data with pseudoreplicates

Re: Proc GLM multiple comparison using Bonferroni adjustment test

Re: Proc GLM multiple comparison using Bonferroni adjustment test