Hi Everyone,
I run the following regression and extract the results into 2 table report1 and report2.
It takes very long time and I think it is caused by the Result Viewer where SAS tries to all regression graph for each By Group.
Could you please tell me if I can add any condition to stop the Result Viewer printing and still get the report I want?
When I try the NoPRINT option, report1/2 are not created.
Thank you.
HHC
proc reg data=data6a ;
ods output ParameterEstimates=report1(drop=df);
ods output FitStatistics=report2;
by yq0 ;
model ab3_ret12 = cbr_s;
run;
NOTE: The above message was for the following BY group:
yq0=200101
WARNING: ODS graphics with more than 5000 points have been suppressed. Use the PLOTS(MAXPOINTS= ) option in the PROC REG
statement to change or override the cutoff.
ODS GRAPHICS OFF;
proc reg data=data6a ;
ods output ParameterEstimates=report1(drop=df);
ods output FitStatistics=report2;
by yq0 ;
model ab3_ret12 = cbr_s;
run;
ODS GRAPHICS OFF;
proc reg data=data6a ;
ods output ParameterEstimates=report1(drop=df);
ods output FitStatistics=report2;
by yq0 ;
model ab3_ret12 = cbr_s;
run;
ods graphics off;
ods exclude all; /* all open destinations */
ods results off; /* no updates to tree view */
proc reg
...;
quit;
ods graphics on;
ods exclude none;
ods results on;
Are you ready for the spotlight? We're accepting content ideas for SAS Innovate 2025 to be held May 6-9 in Orlando, FL. The call is open until September 25. Read more here about why you should contribute and what is in it for you!
Learn how use the CAT functions in SAS to join values from multiple variables into a single value.
Find more tutorials on the SAS Users YouTube channel.