ERROR:in SAS EG-Some code points did not transcode.

[sathya66]

Hi ,

I am trying to run one macro in EG.

I am getting below error in workspace logs not in sas EG sas session log. is this with encoding issue.

2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000306] :test_user -
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.
2020-10-05T16:52:10,204 ERROR [00000005] :test_user - Some code points did not transcode.

[Kurt_Bremser]

Most likely caused by sending UTF characters in code to a workspace server with a non-UTF encoding.