- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
I successfully created a library named NP, but when I click on it does not open
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
In the log is says: Libref Np was successfully assigned as follows:
Engine: XLSX
I did have a expand sign by NP, I double click on it and it went away now it’s just NP folder.
Please help,
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
Please show the log including the code and the messages that follow the code.
Amir.
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
LOG
Libname np xlsx “folder/myfolders/EPG194/data/np_info.xlsx”;
Note: Libref NP was successfully assigned as follows:
Engine:
Physical Name: /folder/myfolders/EPG194/data/ np_info.xlsx
run;
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
Engine: XLSX
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
So I did noticed in my path I left out and (s) in folder, but I did not it matter since I saw NP under My Libraries.
Should I run it again listening the s
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
I figured out what the problem was. I was missing some data
- Mark as New
- Bookmark
- Subscribe
- Mute
- RSS Feed
- Permalink
- Report Inappropriate Content
Well spotted. I recommend you mark your own solution correct (not my post), so if anyone else has the same symptom then your solution might be the same for them.
Amir.