In my sample code I am using wrong code as
data one;
a;
run;
to get error.
%macro errmail;
data _null_;
file myfile;
put 'Your job received the following ERROR/WARNING message:';
put;
put 'ERROR was:';
put "&syserrortext";
put;
put 'WARNING was:';
put "&syswarningtext";
run;
%end;
%mend errmail;
data one;
a;
run;
/*%put &syserr; or %put &syserrortext;*/
%errmail;
Entire code mentioned in the above, you can see there.
I am using this part to get mail as you can see
Filename myfile email
to= "xxx.xxxx@xxx.xxx"
subject= "Error in Report"
type= "text/plain"
importance="HIGH";
Now in the section where error should be mentioned specifically, there I am using generic condition as
%macro errmail;
data _null_;
file myfile;
put 'Your job received the following ERROR/WARNING message:';
put;
put 'ERROR was:';
put "&syserrortext";
put;
put 'WARNING was:';
put "&syswarningtext";
run;
%end;
%mend errmail;
data one;
a;
run;
/*%put &syserr; or %put &syserrortext;*/
%errmail;
But here instead of %put I want to use like
%macro errmail;
%if "&syserrortext" is "Statement is not valid or it is used out of proper order." %then %do;
data _null_;
file myfile;
put 'Your job received the following ERROR/WARNING message:';
put;
put 'ERROR was:';
put "&syserrortext";
put;
put 'WARNING was:';
put "&syswarningtext";
run;
%end;
%mend errmail;
data one;
a;
run;
/*%put &syserr; or %put &syserrortext;*/
/*"ERROR 180-322: Statement is not valid or it is used out of proper order.";*/
/*I need to mention the above error specifically*/
/*I need to send mail only for this error not for all error*/
%errmail;
The condition should be specific not generic. I want to get mail in respect to only one error. I am using this error for example.
