EM workflow execution order

[rmlmrmlm]

Hello!

Imagine a EM diagram with 6 steps.

I executed successfully this diagram from step 1 to step 6.

I needed to make some changes on step 5.

I executed again the diagram. I guess it would execute only steps 5 and 6 but it didn't! It started on step 3.

I don't know why because there were no changes on the steps 1,2,3,4!

Any suggestions why this happened?

Thank you very much.

[WendyCzika · Accepted solution]

Can you provide more details?  Nodes should only rerun when one of their properties changes, unless Rerun=Yes in the Input Data node.  Also you can check the Last Run Time property for the node in the Status section to see if it actually reran.

[rmlmrmlm]

Your reply was perfect. Thank you!