Hello all!
The below pasted default output tables for Proc GLM /repeated is annoyin me and I can't seem to figure out how to run the GLM's without the talbe.... Does anyone know how to stop this from appearing???
Thanks all !!
I believe that is the MultStat table, which is produced by default when you use the MANOVA statement. You can omit the MANOVA statement, or you can use ODS EXCLUDE to suppress that table:
ods exclude MultStat;
proc glm data=...;
MANOVA ...;
etc;
quit;
I believe that is the MultStat table, which is produced by default when you use the MANOVA statement. You can omit the MANOVA statement, or you can use ODS EXCLUDE to suppress that table:
ods exclude MultStat;
proc glm data=...;
MANOVA ...;
etc;
quit;
NICE. ACTUALLY, I'M NOT USING A "MANOVA" STATEMENT AT ALL, IT'S JUST DEFAULT FOR ANYTHING WITH A "REPEATED" STATEMENT MAYBE?
ANYWAY, IT WORKED WHEN I WROTE:
ODS EXCLUDE MULTSTAT(PERSIST);
!
THANKS SOOOOOO MUCH. THAT WAS SO ANNOYING.
Glad it worked. In general, you can use ODS TRACE ON to figure out the names of the ODS tables, and then use ODS exclude to suppress the table. See the article "Find the ODS table names produced by any SAS procedure."
Add the statement
ods exclude multstat(PERSIST);
before PROC GLM and
ods exclude none;
after the run; statement.
Are you ready for the spotlight? We're accepting content ideas for SAS Innovate 2025 to be held May 6-9 in Orlando, FL. The call is open until September 25. Read more here about why you should contribute and what is in it for you!
Learn how use the CAT functions in SAS to join values from multiple variables into a single value.
Find more tutorials on the SAS Users YouTube channel.