I know there are some minor differences between the capabilities of the parameter interface for EG versus the Portal (v9.1.3). Can anyone tell me what these are?
I have a stored process that I created in EG...actually I wrote a macro then put it in EG. In EG the stored process runs fine...it does not run in the Portal. I don't think it is a security issue because the parameter group headers do appear...so the portal is accessing the SP...but if I click on a group header nothing happens. I think it may have something to do with the 20 or so parameters I set up. Any ideas?
Otherwise, if that's not it, you might check with Tech Support for more help. They can look at your SP registration and help you figure out what's wrong.
Secure your spot at the must-attend AI and analytics event of 2024: SAS Innovate 2024! Get ready for a jam-packed agenda featuring workshops, super demos, breakout sessions, roundtables, inspiring keynotes and incredible networking events.
Register by March 1 to snag the Early Bird rate of just $695! Don't miss out on this exclusive offer.