I have never seen this before while using RSUBMIT.   I run code using remote submit and all is fine.   Then if I run a piece of code and there is an error, such as:   NOTE: Remote submit to ROMOTE complete. 85 86 rsubmit; NOTE: Remote submit to ROMOTE commencing. 216 data all_data1; 217 merge out_1 (in=a) 218 rank_ons_vis_summ2 (in=b); ERROR: File WORK.RANK_ONS_VIS_SUMM2.DATA does not exist. 219 by postcode_sector; 220 if a; 221 run; NOTE: The SAS System stopped processing this step because of errors. NOTE: SAS set option OBS=0 and will continue to check statements. This may cause NOTE: No observations in data set. WARNING: The data set WORK.ALL_DATA1 may be incomplete. When this step was stopped there were 0 observations and 93 variables. From this point on all the tables will open and show data in them, but if I run anything else, SAS will come back as though the table is empty. For example the table OUT_1 has data in it, but if I run code after an error I'll get:   88 rsubmit; NOTE: Remote submit to ROMOTE commencing. 231 data out_1f ; 232 set out_1; 233 234 run; NOTE: The data set WORK.OUT_1F has 0 observations and 93 variables. WARNING: Data set WORK.OUT_1F was not replaced because this step was stopped. NOTE: DATA statement used (Total process time): real time 0.03 seconds user cpu time 0.00 seconds system cpu time 0.00 seconds Memory 305k OS Memory 8996k Timestamp 9/26/2016 3:58:10 PM NOTE: Remote submit to ROMOTE complete. The only way that I can reset this is to shut down SAS and start it up again.   What else can I do??   ... View more