I've successfully used the RTF destination and sent section data to it to set the Header and Footer margin in the RTF output file, as follows:
ods RTF sectiondata='\headery720\footery576';
this corresponds to a 0.5 in header margin and a 0.4 in footer margin.
But when I try to do the same with the tagsets.RTF destination, via the following syntax:
ods tagsets.RTF options(SECT=''\headery720\footery576');
the end result is a line in the RTF file that sets the header and footer margin correctly ... but then it is immediately followed by a line generated by the tagsets, that resets the header and footer margin to 1440 (i.e. 1 in which is the top and bottom margin settings).
I note that in the tagsets.RTF the following "offending" language is probably the culprit:
put $sect_data;
put NL;
put "\headery" TOPMARGIN "\footery" BOTTOMMARGIN;
put "\marglsxn" LEFTMARGIN "\margrsxn" RIGHTMARGIN;
put "\margtsxn" TOPMARGIN "\margbsxn" BOTTOMMARGIN;
set $pagecols PAGE_COLUMNS /if exists( PAGE_COLUMNS);
put NL;
which as I guessed using the TOPMARGIN AND BOTTOMMARGIN values to 'reset' the header and footer margins.
I really like some of the features of the tagsets.RTF destination over those of the RTF destination --- and as such would really like to use it ... but w/o being able to correctly set the header and footer margins I can't change yet.
Any workarounds/solutions?