viewing and opening table by double click on the table?

[Inp]

Hi
I have SAS 9.1.3 service pack 4. When I open a table by double click on it,it is not viewing the table. All I see SAS 9.1 pop and then disappear immediately but nothing open the table. I can open the table by opening SAS first then from Table view.

Can any body tell me how to setup / configure the default setup, so that I can open SAS table by double clicking on it, rather going open SAS first and then open by Table view.

Your help is much appreciated.


Thanks

Inp

[Cynthia_sas]

Hi,
This doesn't seem like a stored process question. If you have the Enterprise Intelligence Platform installed, then each of the client applications has a way for you to either view or point to a data source.

If you have a local version of SAS installed (which seems to be what you describe) and/or SAS Enterprise Guide and you are having this problem, then perhaps one of these Tech Support notes is relevant:
http://support.sas.com/kb/18/844.html
http://support.sas.com/kb/11/827.html
http://support.sas.com/kb/19/148.html
http://support.sas.com/kb/5/413.html
http://support.sas.com/kb/1/635.html

However, your best bet for help with this issue is to contact Tech Support. They can determine your operating system and configuration and guide you through the troubleshooting steps to figure out the solution.

To send a question to Tech Support, go to http://support.sas.com/ and in the left-hand navigation pane, click on the link entitled "Submit a Problem".

cynthia