Help using Base SAS procedures

pdf hsize= issue in SAS 9.2

Reply
Contributor
Posts: 28

pdf hsize= issue in SAS 9.2

Ever since upgrading to SAS 9.2, I've been getting the following error when trying to output to a multi page PDF:

WARNING: The specified value of 10.5000 inches for HSIZE= is larger than 8.0000 inches which is the maximum for the device PDFC. HSIZE is ignored.
NOTE: The above message was for the following BY group:
SpecialtyGroupDescription=ANESTHESIOLOGY

There are 50+ specialties and the first page (first by group) prints out fine with a full page of width 10.5. However, from the second specialty on, the page is pushed down to a width of 8 and just looks compressed. Does anyone have any ideas? I'd like to avoid running this one update in 9.1.

10.5 shouldn't be an issue for any page as it is set to landscape.

goptions reset=all device=PDFC gsfname=output gsfmode=replace rotate=landscape;

Thanks.
Contributor
Posts: 28

Re: pdf hsize= issue in SAS 9.2

Apologies. Probably not the best forum to post this. I'll post in the SAS/GRAPH forum. Please feel free to delete, admin.
Ask a Question
Discussion stats
  • 1 reply
  • 99 views
  • 0 likes
  • 1 in conversation