Data visualization with SAS programming

Proc Gchart Raxis error : Order= clause on the axis statement is not valid. The default axis used

Accepted Solution Solved
Reply
Contributor
Posts: 31
Accepted Solution

Proc Gchart Raxis error : Order= clause on the axis statement is not valid. The default axis used

Hi,

 

I have Raxis values ranging from -80 to 0 in proc gchart.

 

i specified as 

axis2 order = (-70 to 0 by -10)
offset=(0,0)
minor = none
value = (h=1);

 

but i log i see 

"WARNING: Order= clause on the axis statement is not valid. The default axis values will be used."

 

i'm getting -60 to 0 range values in output. not from -80 to 0.

 

please help.


Accepted Solutions
Solution
‎07-01-2016 08:50 PM
Grand Advisor
Posts: 9,702

Re: Proc Gchart Raxis error : Order= clause on the axis statement is not valid. The default axis use

Use

axis2 order = (-70 to 0 by 10)
offset=(0,0)
minor = none
value = (h=1);

The code you originally showed in effect tells SAS to: start the left hand side at a value of -70, decrease by 10 at each step to the right and end at 0.

 

 

Since the default axis shows -60 I actually doubt that you have values of -80 to display. And if you want to see -80 then starting at -70 would exclude them. To see -80 when you specify an order list then you need to make the upper and lower bounds such that the expected values are displayed.

View solution in original post


All Replies
Solution
‎07-01-2016 08:50 PM
Grand Advisor
Posts: 9,702

Re: Proc Gchart Raxis error : Order= clause on the axis statement is not valid. The default axis use

Use

axis2 order = (-70 to 0 by 10)
offset=(0,0)
minor = none
value = (h=1);

The code you originally showed in effect tells SAS to: start the left hand side at a value of -70, decrease by 10 at each step to the right and end at 0.

 

 

Since the default axis shows -60 I actually doubt that you have values of -80 to display. And if you want to see -80 then starting at -70 would exclude them. To see -80 when you specify an order list then you need to make the upper and lower bounds such that the expected values are displayed.

Contributor
Posts: 31

Re: Proc Gchart Raxis error : Order= clause on the axis statement is not valid. The default axis use

Awesome thanks 
Post a Question
Discussion Stats
  • 2 replies
  • 163 views
  • 0 likes
  • 2 in conversation