01-22-2018 11:57 AM
By default the option REPLACE is enabled. You can use following files to update with NOREPLACE.
sasv9_local.cfg : ~/SASHOME/SASFoundation/9.4/ (i.e ~/SASRoot)
you can also set this option in autoexec_usermods.sas located at: ~/SASCONFIG/Lev1/SASApp/WorkspaceServer
remember to use the Autoexec option included in sasv9_local.cfg.
01-22-2018 02:21 PM
In our test environment we get this message when running SAS processes
WARNING: Data set SASDATA.XXX was not replaced because of NOREPLACE option.
In production we don't get this message so I was trying to figure out where this NOREPLACE option is set but I can't find it. I checked sasv9.cfg files in multiple locations but I don't see this option in any of these .cfg files...
01-22-2018 02:28 PM
The NOREPLACE option can be set in several places:
01-23-2018 04:11 AM
Use the below code to identify the location of config files:
proc options option=config;
In the log, check for the below information:
SAS (r) Proprietary Software Release 9.4 TS1M3
01-22-2018 11:59 AM
And if you're not an administrator you can use the OPTIONS statement to set this as well.
01-22-2018 11:08 PM
Use the below code to see where SAS is reading the value from:
proc options option=replace value; run;