08-12-2013 04:23 PM
When I am at the base of Log and scroll up, I am sent half a page up. How do I reset that to the usual way a scroll works?
Note: I did not find the specific Community for this type of question, so I ask here.
08-12-2013 05:38 PM
I use Windows 7 and it is the middle scroll wheel of the mouse. The scroll toolbar also goes up half a page when I do that. It is something that had bothered me for a long time, so it's not an accident.
08-12-2013 05:47 PM
I'm not sure if it will help but from the Log go to the Tools=>Options=>Log=>General. The dialog box will show a section for Scroll. If the Vertical is currently showing Half then you might try one of the other options, possibly CURSOR.
08-12-2013 05:55 PM
Thanks, I think depends on what kind of info was placed in log or something else because now it works. I will get back when the issue happens again.
08-13-2013 10:47 AM
If you are running code written by someone else look for DM statements that involve the LOG. That might be the cause of an intermittent behavior.
02-26-2014 09:58 PM
ok, I ran a macro twice which generates some amount of data
This scrolling problem appears: when I scroll from bottom, I am sent a considerable space somewhere up.
However, if I give dm log 'clear'; (clearing the log) and run the macro once, the scroll works as a normal mouse cursor.
The setting up of scrolling->vertical as indicated above by ballardw does not have any effect.