Architecting, installing and maintaining your SAS environment

Installation of SAS HPA

Accepted Solution Solved
Reply
Frequent Contributor
Posts: 126
Accepted Solution

Installation of SAS HPA

I have installed the SAS VA 7.3 on distibuted environment sucesfully. Could you please guide me step by step process to install SAS HPA. I am following the below book to install the sas hpa Co-Located data.

 

http://support.sas.com/documentation/onlinedoc/hp-analytics-infrastructure/31/hpaicg.pdf

 


Accepted Solutions
Solution
‎03-20-2017 05:35 AM
Trusted Advisor
Posts: 1,326

Re: Installation of SAS HPA

Posted in reply to japsas100

On the pages 17 and 18 you can see the steps to configure it, which involves to create krb5.keytab file and some variables on the ssh_config file, such as GSSAPIDelegateCredentials=yes.

View solution in original post


All Replies
Trusted Advisor
Posts: 1,326

Re: Installation of SAS HPA

Posted in reply to japsas100

Hello @japsas100,

 

that is a bit of a hard one, very general. We don't know much about your HW, SW and general deployment. Plus iwhat you are asking here would take quite a lot of time. For that purpose, I would rather recommend you to request support from SAS Technical Support or a SAS Consultant (or a trusted SAS Partner).

 

But let me give you some bits of  practical highlights, let see if they can help you a bit:

  • You got the right document. The first thing you need to do are:
    • to get a Hadoop specialist available for you,
    • and get the Pre-requisites ready. On your link, the second chapter, page 13. All of them, and better not to continue until they are 100% OK. Good pre-requisites will give you more than 50% of success options. Check if you need the optional configuration on the Chapter 4. 
  • Once you got the pre-requisites in place, including the Hadoop cluster, and all fo them can be independently validated (such as the SSH trusted connections and Kerberized trust).
Frequent Contributor
Posts: 126

Re: Installation of SAS HPA

Posted in reply to JuanS_OCS

Thanks JuanS_OCS

 

Its mandatary to required Kerberos. How we can check whether we are using Kerberos in prod env.(already installaed and running)

Solution
‎03-20-2017 05:35 AM
Trusted Advisor
Posts: 1,326

Re: Installation of SAS HPA

Posted in reply to japsas100

On the pages 17 and 18 you can see the steps to configure it, which involves to create krb5.keytab file and some variables on the ssh_config file, such as GSSAPIDelegateCredentials=yes.

☑ This topic is solved.

Need further help from the community? Please ask a new question.

Discussion stats
  • 3 replies
  • 158 views
  • 0 likes
  • 2 in conversation