12-30-2014 06:10 PM
One of the steps in the post installation activities on the Compute server (as per the 'Instructions.html' document) is to run validation tests using SAS Management Console, and to run the Deployment Tester suite of tests from SAS Management Console. The Deployment Tester suite checked out ok on all but the SAS IQ test which had 1 failure, when it found a checksum error in sasenv_local.
Why did this checksum error happen, and what needs to be done to fix it?
12-31-2014 11:01 AM
New installation of SAS 9.3. I have finished the Install and Configure steps using SAS Deployment Wizard, and am now doing the post configuration steps which involve validation etc. from SAS Management Console.
12-31-2014 02:42 PM
12-31-2014 03:26 PM
I did not choose to run SAS IQ after SAS OQ. The Deployment Tester did it in that sequence when I selected to execute the full suite of tests.
So does this error happen for everyone ?
With regard to file contents being changed, as per the documentation on configuration tasks to be done after install (see document http://support.sas.com/documentation/installcenter/en/ikfdtnurnxcg/64205/PDF/default/config.pdf) I had to make changes in sasenv_local in /SASROOT/SASFoundations/9.3/bin to add the LIBNAME statements.
In short is this error not severe enought to warrant fixing before proceeding with the rest of the install/configuration?
01-01-2015 09:04 AM
you should not modify that file as there is a usermods version of that.
The libname are to be solved differently as there are usermod-files for all on the sasapp config level.
01-07-2015 03:59 PM
A SAS consultant had instructed us to make the change in the sasnev_local file in SASHOME/SASFoundations/9.3/bin folder.
I realized I should have done the checksum validation before I made the change in the file, as the validation was to confirm the install was completed corectly. The error disappeared once I reverted the sasenv_local to its original state,before running the Deployment Tester suite of tests for SAS IQ.