topic Re: if index (...) then gives correct reults but if IN (..) not? in SAS Procedures

if index (...) then gives correct reults but if IN (..) not?

Mirisage — Mon, 10 Mar 2014 14:52:30 GMT

Hi Sas Forum,

I Have the attahced k_1 data set.

I wanted to create a flag with the following condition.

if STATUS in("CURRENT") then Delq_Flag=0;

else Delq_Flag=1;

So, I used below code.

data k_3;

set k_1;

if STATUS in("CURRENT") then Delq_Flag=0;

else Delq_Flag=1;

run;

Q: But above code doesn't give correct results although the logic seems correct. But below code provides the intended resutls. I cannot understand what is happening. Coudl someone help me to understand.

data k_2;

set k_1;

if index(STATUS,"CURRENT") then Delq_Flag=0;

else Delq_Flag=1;

run;

Thanks

Miris

Re: if index (...) then gives correct reults but if IN (..) not?

Reeza — Mon, 10 Mar 2014 15:17:36 GMT

Your dataset is protected, probably for good reason.

Run a proc freq on your variable of interest. Most likely it has trailing blanks or some other letters that cause it not to be an exact match.

Current is not equal to "Current " (3 extra spaces)

but the index function would return a match.

EDIT: Trailing blanks are not an issue, Leading Blanks would cause a mismatch.

Re: if index (...) then gives correct reults but if IN (..) not?

Tom — Mon, 10 Mar 2014 15:35:42 GMT

In SAS trailing blanks are meaningless, but leading blanks can cause these type of behavior. Leading blanks can be hard to see are they normally do not appear when using PUT as it will trim them. You can see them better if you use the $QUOTE. format.

data k_2;

set k_1;

if index(STATUS,"CURRENT") and not STATUS in ("CURRENT") then put status $quote. ;

run;

Re: if index (...) then gives correct reults but if IN (..) not?

data_null__ — Mon, 10 Mar 2014 16:01:03 GMT

Are you sure?

data _null_; 
   x = 'Current' eq 'Current   '; 
   put x=;
   run; 


x=1

Re: if index (...) then gives correct reults but if IN (..) not?

Reeza — Mon, 10 Mar 2014 16:03:53 GMT

Thanks Tom and John for the corrections.

Only leading blanks are an issue.

Re: if index (...) then gives correct reults but if IN (..) not?

Mirisage — Tue, 11 Mar 2014 16:14:58 GMT

H Tom, Reeza and Data_null,

Many thanks to each one of you for this contribution.

Regards

Miris