topic Re: Justify the text in SAS Programming

Justify the text

SASdevAnneMarie — Fri, 14 Aug 2020 08:22:16 GMT

Hello experts,

Do you know please how to justify the text (I would like to have the same margins at right and at left) like in attached picture.

I know the option Just=L/C/R but it is alignment.

Thank you very much!

Marie

Re: Justify the text

JosvanderVelden — Fri, 14 Aug 2020 09:54:05 GMT

Have a look at the solution in this thread: https://communities.sas.com/t5/ODS-and-Base-Reporting/Can-ODS-TEXT-do-justified-alignment/td-p/576677

Re: Justify the text

SASdevAnneMarie — Fri, 14 Aug 2020 11:02:51 GMT

Thank you!
As I understood there is no SAS solution to do the FULL Justification...

Re: Justify the text

ballardw — Fri, 14 Aug 2020 14:50:12 GMT

Justify what? A single cell in a report table? A column in a report table? A report table? and entire report?

Any specific procedure?

In what type of output document (i.e. ODS destination)?

Re: Justify the text

SASdevAnneMarie — Fri, 14 Aug 2020 14:56:16 GMT

Hello,
I have the same text problem as Jowinniejo
here https://communities.sas.com/t5/ODS-and-Base-Reporting/Can-ODS-TEXT-do-justified-alignment/td-p/576677
Thank you

Re: Justify the text

ballardw — Fri, 14 Aug 2020 15:45:29 GMT

@SASdevAnneMarie wrote:
Hello,
I have the same text problem as Jowinniejo
here https://communities.sas.com/t5/ODS-and-Base-Reporting/Can-ODS-TEXT-do-justified-alignment/td-p/576677
Thank you

Note that a possible solution in that link depends on the ODS destination. Which you have not specified. If you need this for a specific file type, you need to tell us.

To a certain amount, the procedure creating output also would require different approaches, which you have not specified.

Re: Justify the text

SASdevAnneMarie — Fri, 14 Aug 2020 15:58:51 GMT

Thank you for your answer.
I have the same approche as Jowinniejo:
ods escapechar="^";

ods pdf file="….\test.pdf" ;

ods layout start X=0in y=0in ;

ods region x=0.8in y=1.3in;

/**********/

ods layout end;

ods pdf close;