topic Re: Communication Subsystem Protocol Error for SAS DI Parallel processing job in SAS Data Management

Communication Subsystem Protocol Error for SAS DI Parallel processing job

pawan — Fri, 04 Oct 2019 16:05:07 GMT

Dear Experts,

As I was trying to workout a Prallel processing step using a Loop job in DI Studio, I'm encountering with below error messages

ERROR: A communication subsystem message transmission request faillure has occured.

ERROR: Communication Subsystem Protocol Error: Send attempted in receive state.

It looks like the Remote Singons are working properly but seeing this message during the Remote Signoff state. As I found some solution worked for someone on this forum where the suggestion was to make changes to logconfig.xml for the section Per.ARM and I see that the values are set as mentioned in the solution(level value = "WARN"). But I'm still seeing this issue. Any suggestions would be highly appreciated

Thanks in advance,

Pavan

Re: Communication Subsystem Protocol Error for SAS DI Parallel processing job

SAS_Cares — Fri, 04 Oct 2019 13:31:30 GMT

Pavan, see if this problem note may help:

Problem Note 60708: Enabling ARM logging causes "ERROR: Communication Subsystem Protocol Error: Send attempted in receive state" to occur in your log

http://support.sas.com/kb/60/708.html

Re: Communication Subsystem Protocol Error for SAS DI Parallel processing job

pawan — Fri, 04 Oct 2019 16:13:18 GMT

Dear SAS_cares,

Yes, that is the post I was referring to in my message. If you relook into my message you can find me mentioning that the xml config file is exactly coded in the same way as suggested in that solution but I'm still seeing the same error. The job actually works fine if I'm not pointing it for parallel run. Look forward for further suggestions. Thanks!